Installation instruction Aqua 3000
Aqua 3000 dissolving process
The AQUA prevents building of lime, without affecting the taste of the water. All positive characteristics of the water, including minerals, are maintained. The lime dissolver produces a modulated low frequent field in the water flow inside the pipe. This is a reliable and environment friendly method that prevents the use of chemical water softeners. The AQUA protects equipment and machinery that uses water and reduces maintenance cost.
AQUA also dissolves existing lime deposits in the pipe circuit. Depending on the amount of deposits, this process could take typically between 1 to 6 months. Shortly after a lime dissolver has been installed, the colour of the water may change temporarily. This in fact proves the effectiveness of the system.
Where to install
The AQUA lime dissolver should be installed on the incoming pipe, as close as possible to the water supply. For installations in a building, this is usually immediately after the meter, and before separation (if any) into smaller pipes. Aqua system is suitable for fitting on both horizontal and vertical pipes, made from metal or plastic. Both ends of an inductive winding around the pipe are connected to the lime dissolver. Next to this central coil there are two capacitive windings, which are connected at one end only. The AQUA 3000 works with 3 coils (windings) that have 4 wires connected.
Product package includes: 1 roll cable, 4 terminal connectors, 6 cable binders, 4 screws + wall plugs.
Select a free spot of minimum 30 cm on the water-incoming pipe.
Mount the lime dissolver close to this location, preferably to a wall.
Clean the selected part of the pipe, and remove paint (if any).
In the middle of the free spot, make a coil of 23 windings around the pipe.
Fix the outside ends of the coil winding to the pipe, using cable binders.
Cut off connection wires to maximum 100 cm, and attach terminal connectors.
Make capacitive coils, one left and one right, with 2 cm free space between all coils.
Verify that all windings have the same direction (see diagram).
Fix the capacitive coils (7 windings each) onto the pipe, using cable binders.
Attach terminal connectors to the inner wire ends, which are max. 100 cm long.
Cut off the other wire ends, just outside cable binders (these ends are not connected).
Attach four terminal connectors to the lime dissolver, as shown in the diagram.
Make sure that the cables to the lime dissolver are free from any mechanical force.
Plug power cord into 230 V. Immediately LED indicates that the lime dissolver is in function.
Factory guarantee
The manufacturer guarantees that this product is free from defects in material and manufacturing errors at time of purchase. Should there be any defect within 4 years after date of purchase, the product is repaired of exchanged free of charge. This guarantee does not apply for problems caused by wrong installation or modifications to the product.
Safety
The CE-marked system does not affect other equipment and meets all European EMC-guidelines for electromagnetic compatibility. The unit has a built-in power supply and meets IP65, which makes it suitable for applications in moist circumstances.
Important
If the power cord of the lime dissolver is damaged, the whole unit needs to be replaced. It necessary, use an extension cable.
